What can it be, what do I need to change and what am I missing? I've tried the wizard, the graphical config and manual, but I've had no luck.
Vpn tracker 10 password#
The shared secret and usernames and password have been double checked, triple checked and quadruple checked. This is after trying a number of suggestions, so a few miscelaneous things might have slipped in. Tunnel-group DefaultRAGroup ipsec-attributes Tunnel-group DefaultRAGroup general-attributes Username user2 password DLablablaNw= nt-encrypted Username user1 password KUYNblablaSS encrypted privilege 15 Policy-map type inspect dns preset_dns_map
Snmp-server enable traps snmp authentication linkup linkdown coldstartĬrypto ipsec transform-set exampletrans esp-3des esp-sha-hmacĬrypto ipsec transform-set exampletrans mode transportĬrypto dynamic-map dyno 10 set transform-set exampletransĬrypto map vpn 10 ipsec-isakmp dynamic dyno Nat (inside) 0 access-list inside_nat0_outbound Icmp unreachable rate-limit 1 burst-size 1 Same-security-traffic permit intra-interfaceĪccess-list inside_nat0_outbound extended permit ip any 10.20.30.192 255.255.255.224Īccess-list outside-in-1 extended permit tcp any interface outside eq 14841Īccess-list DefaultRAGroup_splitTunnelAcl extended permit ip any 10.20.30.0 255.255.255.0Īccess-list DefaultRAGroup_splitTunnelAcl_1 standard permit anyĪccess-list meulnet_splitTunnelAcl standard permit any Same-security-traffic permit inter-interface
Vpn tracker 10 mac#
It actually has the same messages twice in a row, with a 10 second interval, every time I try to connect from the Mac.Ĭurrently I am trying this without the VPN Tracker running and the Mac is connected to the same switch as the ASA is, but both have an external public IP address. Sun Oct 12 16:19:41 2008 : IPSec phase 1 client started Sun Oct 12 16:19:41 2008 : IPSec connection started From the Mac side, I can only see this in the ppp.log:
I've managed to get the initial IPSec connection up, but it then fails.
I've followed the Cisco instructions, but there's no joy.
Vpn tracker 10 mac os x#
The Cisco VPN client won't run while the VPN Tracker is running, so I want to configure the build-in Mac OS X VPN client.
I may not be very eloquent currently, as I've wasted yet another day on trying to get this VPN set up.Ī mac that has a VPN Tracker connection to a Juniper somewhere else needs to also connect to my VPN.
0 kommentar(er)
